WUPP Bluetooth 5.1 S2 Motorcycle Helmet Full Duplex Bluetooth Intercom Headset Earphone – Waterproof, Bluetooth

WUPP Bluetooth 5.1 S2 Motorcycle Helmet Full Duplex Bluetooth Intercom Headset Earphone – Waterproof, Bluetooth.

Key Features:

• Bluetooth version: Qualcomm CSR 5.1 Bluetooth chip
• Play time: 22 hours or more
• Standby time: 400 hours
• Charging time: about 2.5 hours
• Charging interface: TYPE-C Android phone plug
• Power requirement: charging requirement 5V1A
• FM support range: 87-108M
• Installation method: clip installation, hook and loop fastener installation
• The product adopts Bluetooth 5.1 chip, which is more power saving, low latency, no noise, realizes stable audio transmission, supports pairing with most...
• The product adopts CVC8.0 double-meter noise reduction, DSP software algorithm intelligent quadruple noise reduction, which can ensure the quality of the...
• The intercom distance can reach 800-1000 meters, when the Bluetooth hands-free answering the phone, the distance is more than 20 meters, can support three...
• The product can be connected to two mobile phones at the same time to realize the control of the basic functions of the mobile phone, (receiving calls,...
• The product uses 800mAh super-capacity rechargeable polymer lithium battery, talk time 22 hours, standby time 400 hours; support IOS, part of the ANDROID...
• The product design is IP67 waterproof, even if it is used in rain or snow, it will not be affected at all
• The product adopts multi-function buttons with large rotating parts, the button layout is reasonable, the function area is clear, and the blind operation of...
• The product is equipped with soft and hard two-in-one earphones, hook and loop fastener bottom clips, front and rear bottom clips, suitable for any kind of...
• Support K line, connect to ordinary walkie-talkie
• Installation steps:
• Loosen the screw on the back of the fixture with the provided screwdriver
• Open the inner lining of the helmet, insert the clamp into a suitable position on the left side of the helmet and tighten the screw (over tightening the...
• Slide the machine into the clamp, make sure it is securely locked
• Open the inner lining of the helmet (at the ear position), clean the surface of the EPS, and stick the hook and loop fastener on the rough surface
• Attach the hook surface to the rough surface of the nylon buckle and arrange the helmet lining properly
• Insert the headphone plug into the corresponding headphone jack on the machine to complete the installation

Package Info: Weight: 0.35kgs / 0.77lb, Size: 18cm * 14cm * 5cm / 7.09inch * 5.51inch * 1.97inch

Shipping: Shipping charges and final delivery dates are shown at checkout.