Waveshare ST-LINK/V2 (EN), STM Programmers & Debuggers – Durable Build, Easy to Use

Waveshare ST-LINK/V2 (EN), STM Programmers & Debuggers – Durable Build, Easy to Use.

Key Features:

• Description
• 1. The ST-LINK/V2 is an in-circuit debugger and programmer for the STM8 and STM32 microcontroller families. The single wire interface module (SWIM) and...
• STM8 applications use the USB full speed interface to communicate with STMicroelectronics ST Visual Develop (STVD) or ST Visual Program (STVP) software.
• STM32 applications use the USB full speed interface to communicate with Atollic, IAR, Keil or TASKING integrated development environments.
• Key Features
• 1. 5V power supplied by a USB connector
• USB 2.0 full speed compatible interface
• USB standard A to mini B cable
• SWIM specific features
• 1.65 V to 5.5 V application voltage supported on SWIM interface
• SWIM low-speed and high-speed modes supported
• SWIM programming speed rate: 9.7 Kbytes/s in low speed and 12.8 Kbytes/s in high speed
• SWIM cable for connection to the application via an ERNI standard vertical (ref: 284697 or 214017) or horizontal (ref: 214012) connector
• SWIM cable for connection to the application via a pin header or a 2.54 mm pitch connector
• JTAG specific features
• 1.65 V to 3.6 V application voltage supported on the JTAG interface and 5 V tolerant inputs
• JTAG cable for connection to a standard JTAG 20-pin pitch 2.54 mm connector
• Direct firmware update feature supported (DFU)
• Status LED which blinks during communication with the PC
• Operating temperature 0 to 50 °C
• Application Example
• Connecting the PC and STM8/STM32 application board through ST-LINK/V2 to establish hardware connection
• Connection with STM8 applications
• The ST-LINK/V2 should be connected to the STM8 application via the SWIM cable. Two SWIM cables are delivered with the product:
• - SWIM flat ribbon with a standard ERNI connector at one end and a 4-pin connector at the other end
• - SWIM flat ribbon ended with a 4-pin, 2.54 mm, low-cost connector on two sides
• Connection with STM32 applications
• For STM32 developments the ST-LINK/V2 must be connected to the application using the standard 20-pin female-female JTAG flat ribbon provided.
• ST-LINK/V2 Status
• The LED labeled COM on top of the ST-LINK/V2 shows the ST-LINK/V2 status (whatever the connection type). When the:
• LED is blinking RED: the first USB enumeration with the PC is taking place. If it keeps blinking RED, maybe the USB driver is NOT found.
• LED is RED: communication between ST-LINK/V2 and the PC is established (end of enumeration).
• LED is blinking GREEN/RED: data are being exchanged between the target and the PC.
• LED is GREEN: the last communication has been successful.
• LED is ORANGE: ST-LINK/V2 communication with the target has failed.

Package Info: Weight: 0.10kgs / 0.23lb, Size: 16cm * 9cm * 5cm / 6.3inch * 3.54inch * 1.97inch

Original listing title: Waveshare ST-LINK/V2 (EN), STM Programmers & Debuggers

Shipping: Shipping charges and final delivery dates are shown at checkout.